• Single & Multiple Ranges
• Highest Permeability
• Wide Measurement Range
• Negligible Current Errors
• Low Burden
• Low Uncertainties
The Model 7023/4000 series of High Voltage Current Transformers was designed for the current input to MI’s ALMS 4300 Loss Measurement Systems. This design meets the requirements of both CEI/IEC 44-1 and IEEE STD C57.12.00-2000. The bushing is filled to approximately 72 PSI absolute of SF6 and is fitted with a pressure indicator or with an optional pressure transducer with a 4-20 mA output for continuous monitoring. Connections to the primary winding of the current transformer are made via a copper bar, machined at both ends. Utilizing passive two stage compensated technology, errors of less than 10 ppm can be achieved at high voltages.
The main advantage of a two stage compensated CT is that the effective burden is 0 when feeding into another compensated CT such as the current input on the Model 2010A Wattmeter. As a result, the errors of the CT are effectively reduced to zero in both magnitude and phase. Lead length becomes unimportant and there is no further concern for any additional active components. If the 7023/4000 is connected to a wattmeter that has only a two wire input, the secondary and auxiliary leads must be connected together as close as possible to the input of the wattmeter. Typical errors for burdens at 1Ω are less than 100 ppm. For more accurate data on errors related to burdens above 100 mΩ contact the factory.
The Model 7023/4000 is a four-wire single range passive-two-stage current transformer, which can be supplied to operate at primary currents of either 2000 or 4000 amperes and secondary currents of 1 and 2 amps respectively. The secondary and compensation windings are brought out through a tube and connector in the base of the structure for easy connection. All current transformers have 50% over range capabilities.
The Model 7023/4000 can also be used as a Range Extender for the Model 7010 series of Capacitance/Inductance Bridges for measuring losses in reactors.
Nominal Ratio: 2000:1
Ratio Error < 10 ppm in magnitude and phase
Operating Voltage: 300 kV rms @ 50/60 Hz
Withstand Voltage: 360 kV rms @ 50/60 Hz
Impulse Peak: 650 kV
Partial Discharge: < 10 pC @ 300 kV
Operating Temperature: -5°C to 40°C
Humidity: Up to 95%, non-condensing
Environmental Conditions: Indoor Use Only
Diameter 1.25m x 3.38m ht. 386 kg