News

Measurements International Announces the ICT 200 Calibration System

October 7, 2018

The ICT 200 system has been designed to perform calibration of Isolating Current Transformers with ratios 1:1, 2:1 and 3:1. Test currents are from 1 mA to 100 A (upgradable to 200 A).
In the design of the ICT Test System, the components are mounted and interconnected in a 19-inch rack for easier setup and operation. The main system components are: a 100 A current source, a signal generator, two precision ranging CTs, a current ratio bridge and a system PC.
In order to cover the wide range of testing currents, the system has two possible configurations. One setup covers the range from 2 A to 100 A. In this setup the precision ranging CTs are in circuit in order to step down the input current to the current ratio bridge. The second setup covers the range from 1 mA to 2 A. In this case the two ranging CTs are not in circuit, therefore, the test current and the output current of the UUT (ICT) are going directly to the current ratio bridge inputs.
Only one setup can be used at a time and has to be set manually by the operator by changing connections and leads on the system rear panel. The connections for testing in the rear panel are grouped accordingly in two sections: High current setup and low current setup.

 

Contact MI for More Information

Measurements International Announces the ICT 200 Calibration System

The ICT 200 system has been designed to perform calibration of Isolating Current Transformers with ratios 1:1, 2:1 and 3:1. Test currents are from 1 mA to 100 A (upgradable to 200 A). In the design of the ICT Test System, the components are mounted and interconnected in a 19-inch rack for easier setup and […]

Measurements International Attending Conference on Precision Electromagnetic Measurements (CPEM) 2018

July 5, 2018

CPEM 2018 Paris, France July 8th – 13th, 2018 Measurements International (MI) is pleased to announce GOLD Sponsorship for the CPEM Conference July 8th – 13th in Paris, France.  We invite you to visit our booth (booth 21) to see new and exciting products from MI as well as discuss our new research projects on […]

Measurements International Announces joint research collaboration agreement with METAS

May 1, 2018

Measurements International (MI) Announces a Joint Collaboration with The Federal Institute of Metrology (METAS) to Develop an Impedance Simulator.

PRESCOTT, Ontario – Measurements International (MI) a Metrology Based Company focused on developing products for Electrical Metrology at the primary standards level today announced a Joint Collaboration with The Federal Institute of Metrology (METAS) to develop an Impedance Simulator.